12th Scale Spiral staircase kit

200,00 €

In Stock

12th scale Spiral staircase kit.

This simply beautiful spiral staircase is copied from a Polish original found in an abandoned house. This is the same staircase that we (Mini Vintage) have used in our Old Mill prototype. In the old Mill we use a 'Bottom Step' + 14 'Step Kits' as described below. This product as available on the Mini Vintage site is sold as 'one kit' suitable for use in the 'the Old Mill'. If you would like any different configuration then please order via www.alisondaviesminiatures.co.uk

Each step has stunning filligree and comes with a beautiful bannister post and rail.

The bottom step is slightly different to the other steps as it has a little base finial to finish it off.

The staircase is sold in "steps" with a bottom step option.

Each step measures approx. 15.25mm high x 37mm deep x 68mm wide

The Upright posts are approx. 81mm high with the handrail adding another 2mm to the height.



Bottom Step Kit contents:

1 x step

1 x Bottom hand rail (this is the longer handrail)

1 x Short top handrail

2 x Bannister posts

1 x Little floor flange

1 x Length 12" steel rod (for you to cut to size) (not shown)



Step kit contents:

1 x step

1 x Bannister post

1 x handrail section




Construction

This is a slightly harder kit to construct as it has to be supported during the build.

You will need superglue and a superglue activator (this simply sets the glue instantly and makes the whole job easier).

Always start with the bottom step but it can be constructed outside of the dolls house and then inserted when finished. Your only issue might be that you wont be able to secure the central rod into the floor and the ceiling. Ideally the floor would be added after the stairs are in position.